thanks for the respons but could you make the extra info on the leg switchable with a flag so i can print without the info or with the info
so when we do the preparation of a flight some days in advance we can already print without disturbing info which is not accurate yet.

thanks a lot

Sort of. SkyDemon only loads the scenery around the viewport of the main map, to make efficient use of memory.

The price centre has been enhanced in the forthcoming version to load the scenery for each page as it's printed, so you'll no longer notice this.

I have found something very weird :

i have a long route, i am looking at my origin of my flight on the screen with 1:320000 scale (many detail)
then i press the print centre and go to enroute charts (there the setting is 1:250000) and i see many details
around my origin in the printed charts while i have no details on the other pages.
When I go out of the print centre and I center my view around my destination, then when generating the
previews i loose all detail around my origin on the printed pages and the details only appear on the printed
page around the destination
This must be a bug right!!!!

Hi Skydemon team,

in the latest version of skydemon 3.6.0.0 you have included the time, distance and heading for each leg on the printout
this is a nice feature but it would be even more better if we could select in the enroute chart settings to put this
on/off. The reason id that i print sometimes the enroute charts in advance to study it and to add lots of info
to them. However, at time of printing i dont have the right values of the wind yet .. and then the info given is misleading.
So, being able to select it on or off would be very helpfull.
Also it would be helpfull if we could have a selection to have detailed or summarized enroute charts at print time.
Lately the printed charts contain less info ...
PROBLEM : I noticed that if I go several times into print centre and back that the amount of detail varies a lot
                   sometimes i loose on some pages of the route a lot of roads or waterways...
for example : i am currently preparing a flight from EBUL to EDBM (310 nm) and when I printed the first time i had lots of details on the
                   first page around flanders with all roads etc.. but around hildesheim in Germany i had only the contours of the ground,
                   all roads were gone. So I went out of the print centre and started again. And then i had suddenly no more roads and features
                   in belgium but more features and roads in the hildesheim area ...
                   I could not find a consistent behaviour

Thanks a lot...